TRIMMING HEDGES, BRUSH, VINES AND OVERHANGING TREES IS AS EASY AS HOPPING ON YOUR TRACTOR, SKID STEER, OR SIMILAR EQUIPMENT WITH THE SABRE SAMURAI HYDRAULIC POWERED CUTTER THAT ATTACHES TO ANY LOADER BUCKET.
A hydraulic motor powers an oscillating cam connecting two cutting blades. Varying the hydraulic flow changes the speed of the blades. 2 inch opposing sickle sections allows the cutter to cut material up to 1 1/2″ inches in diameter. (Dependent upon the hardness of the material being cut and pressure provided by the tractor). The 38- in cutter only requires 3 to 4.5 gal/min. hydraulic flow and can be adjusted to cut vertically, horizontally, or at any angle in between with our Deluxe EZ Mount Bracket. This bracket will also allow the trimmer to be positioned upto 40 degrees below grade for trimming around ponds or along ditch embankments. (Please note hydraulic hoses or fittings are not included. #10 ORB Male fittings will be required with hoses).
The Samurai is virtually maintenance free with sealed bearings and a self-lubricating motor. Sickles are easily replaced as they are fastened with capscrews, not rivets.
The Samurai was developed in conjunction with the Canadian Research Council’s Industrial Technology Centre and tested by the Prairie Agricultural Machinery Institute.
FEATURES OF THE SABRE SAMURAI
Adaptable to multiple equipment from subcompact tractors to skid steers
Minimal hydraulic flow requirements allowing for use on almost any equipment
38” cutting bar for wide cutting swath.
Mounting bracket mounts to any size bucket for versatility
High torque hydraulics cuts up to 1 ½” material
Horizontal/vertical & below grade positioning for universal versatility.
Installation and removal in a matter of minutes with simple hand tools
Trimming fall into loader bucket for easy clean up
Maintenance free for ease of use.
Turn your tractor into a complete Ground Maintenance
- Add a Big Tool Rack to carry all your ground maintenance essentials with
you while you trim with your Sabre Samurai.
- Click on the logo below to
learn more from our friends at Big Tool Rack.
|3.0 cu in/rev. High Torque
|Hydraulic oil flow requirements
|3.5 to 4.5 GPM
|Ranges from 500-2,000+ psi depending on thickness of material being cut
|Hose requirements(not included)
|1/2 diameter with #10 ORBM fitting (larger HP tractors)
3/8 diameter with #10 ORBM fitting (subcompact tractors)
|30 lbs Deluxe EZ Mount Bracket
|38 inches (cutting area of knife)