THE VERSATILITY AND PERFORMANCE OF A SAMURAI
TRIMMING HEDGES, BRUSH, VINES AND SMALL TREES IS AS EASY AS HOPPING ON YOUR TRACTOR, SKID STEER, OR SIMILAR EQUIPMENT WITH THE SAMURAI HYDRAULIC POWERED CUTTER THAT ATTACHES TO ANY LOADER BUCKET.
A hydraulic motor powers an oscillating cam connecting two cutting blades. Changing the hydraulic flow changes the speed of the blades. 2 inch opposing sickle sections allows the cutter to cut material up to 1 1/2″ inches in diameter. The 38- in cutter only requires 3 gal/min. hydraulic flow and can be adjusted to cut vertically, horizontally, or at any angle in between. It comes complete with the universal mounting loader bracket.
The Samurai is virtually maintenance free with sealed bearings and a self-lubricating motor. Sickles are easily replaced as they are fastened with capscrews, not rivets.
The Samurai was developed in conjunction with the Canadian Research Council’s Industrial Technology Centre and tested by the Prairie Agricultural Machinery Institute.
Adaptable to multiple equipment from tractors to skid steers
Minimal hydraulic flow requirements allowing for use on almost any equipment
38” cutting bar for wide cutting swath.
Mounting bracket mounts to any size bucket for versatility
High torque hydraulics cuts up to 1 ½” material
Horizontal/vertical positioning for universal versatility.
Installation and removal in a matter of minutes with simple hand tools
Trimming fall into loader bucket for easy clean up
Maintenance free for ease of use.
|3.0 cu in/rev. High Torque
|Hydraulic Oil Flow Requirements
|Approximately 3.5 to 4.5 GPM
|Less than 500 psi during normal operation
|Hose Requirements(not included)
|1/2 inch for tractors with 11 GPM’s or more
3/8 inch for tractors with 10 GPM’s or less
|Deluxe 30 lbs, Standard 20 lbs